AMF 110 Especificações descarregar pdf (Página 232)

AMF Commands

226 New and Enhanced Features in AlliedWare Plus 5.4.4 Major and Minor Versions

show atmf group

This command can be used to display the group membership within to a particular AMF

node. It can also be used with the working-set command to display group membership

within a working set.

Each node in the AMF is automatically added to the group that is appropriate to its

hardware architecture, e.g. x510, x610. Nodes that are configured as masters are

automatically assigned to the master group.

You can create arbitrary groups of AMF members based on your own selection criteria.

You can then assign commands collectively to any of these groups.

Syntax show atmf group [user-defined|automatic]

Default

All groups are displayed

Mode Privileged Exec

Example 1 To display group membership of node2, use the following command:

A typical output screen from this command is shown below:

This screen shows that node2 contains the groups, master and x510. Note that although

the node also contains the implicit groups, these do not appear in the show output.

Example 2 The following commands (entered on node2) will display all the automatic groups within

the working set containing node-1 and all nodes that have been pre-defined to contain

the sysadmin group:

First define the working-set:

Parameter Description

user-defined User-defined-group information display.

automatic Automatic group information display.

node2#

show atmf group

ATMF group information

master, x510

node2#

Node-1#

#atmf working-set node-1 group sysadmin

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 301 302

Sem comentários

AMF 110 Especificações Página 232